KMP B102 Compatible Ink Cartridge for Brother LC3213M, Magenta, 4.7 ml, up to 400 Pages, with Chip

KMP B102 is a magenta ink cartridge made by KMP PrintTechnik AG (Germany) as a compatible replacement for the Brother LC3213M, holding 4.7 ml and rated at up to 400 pages to ISO/IEC 24711 for Brother DCP-J572DW, DCP-J772DW, DCP-J774DW, MFC-J491DW, MFC-J497DW, MFC-J890DW and MFC-J895DW printers.

These compact Brother home and small-office inkjets take four separate LC3211/LC3213 cartridges. This item is the magenta one, matching the higher-capacity LC3213 rather than the starter LC3211, and it carries a chip so the printer shows the ink level.

• 1 × KMP B102 ink cartridge, magenta, 4.7 ml (replaces Brother LC3213M)
• Single cartridge only — the printer, the other colours and any printhead are not included

• Up to 400 A4 pages measured to ISO/IEC 24711.
• Install it exactly like the original: open the ink cover, press the release on the empty cartridge, slide this one in until it locks and close the cover. Remove any orange protective cap or tape first — a cartridge left with its seal on will report as empty or not print.
• Some printers display a "non-genuine" or "used cartridge" notice the first time a compatible cartridge goes in. Confirm the message on the printer panel and printing continues — this is a printer prompt, not a fault in the cartridge.
• These printers stop when any one colour is empty. Because the cartridges are small, keeping a spare magenta alongside the other colours prevents a stop in the middle of a print run.
• For colour-critical photo work, print one test page after the change and compare it with your previous output before a large job.
• Keep spare cartridges or bottles sealed until you need them; ink in an opened container slowly dries at the nozzle or outlet, and a sealed pack keeps the ink in the condition it left the factory.

• It will not fit printers that take LC3219XL, LC3217, LC223 or LC123 cartridges.
• It is magenta only — black, cyan and yellow are sold separately.
• It will not fit the MFC-J5330DW, MFC-J5730DW or other A3 models, which use LC3219XL/LC3217.
• It does not repair a clogged or worn printhead. If the original ink already printed streaks or missing lines, run the printer's cleaning cycle first — new ink cannot fix a printhead fault.