DIGITUS DN-97668 19 Inch 1U Cable Management Panel with 4 Steel Rings and Brush Strip, Light Grey RAL 7035

The DIGITUS DN-97668 is a 1U cable management panel for 482.6 mm (19") cabinets that combines four removable steel rings of 40 x 75 mm with brush strip sections, so patch cords are held in place and pass cleanly between the front and the rear of the rack. It is aimed at network rooms and office cabinets where patch panels and switches sit close together and loose cables start to block airflow and access.

The panel is made from powder-coated sheet steel in light grey RAL 7035, the classic colour of grey DIGITUS and many other 19" cabinets. It occupies one rack unit and mounts on the front 19" profile rails with the installation set supplied in the box.

• 1 x DIGITUS DN-97668 1U cable management panel with 4 steel rings and brush strip sections
• Installation set: screws, cage nuts and washers for mounting on 19" profile rails

• Place one panel directly above or below each 24- or 48-port patch panel or switch: the rings take the horizontal run of patch cords, so the front of the devices stays accessible.
• The brush sections let cables pass through to the rear of the cabinet while closing most of the open gap, which keeps the front neat and helps hold the intended front-to-back airflow.
• The rings are steel rather than plastic clips, so they keep their shape with heavier bundles of Cat6/Cat6A cables and repeated re-patching.
• Because it uses only 1U, it is a practical fit for small wall cabinets as well as full-height floor cabinets.

• It does not fit 10" (254 mm) mini cabinets: the panel is built for 19" profile rails only.
• It is not a vertical cable manager: it organises cables horizontally across one rack unit and does not route cables up and down the side of the cabinet.
• It does not carry load: do not use it as a shelf or to support devices.
• DIGITUS does not publish a maximum cable count per ring, so plan by bundle size rather than a fixed number of cables.