DIGITUS Fiber Optic DIN-Rail Splice Distributor, Angled · 6 × SC duplex or 6 × LC quad · Aluminium, Grey, Unloaded

The DIGITUS DN-96893 is a compact fiber optic splice distributor that clips onto a TS35 DIN rail and terminates an incoming fiber cable onto 6 SC duplex or 6 LC quad adapters. It is built for FTTH, industrial and building networks where fiber has to end inside a control cabinet or distribution board rather than in a 19" rack.

The aluminium housing has an angled front panel, so patch cords leave at an angle and are not crushed by the cabinet door. Inside is a splice cassette that accepts both crimp and heat-shrink splice protectors, with a splice comb for 12 splices (SC) / 24 splices (LC). The cable enters through a U-shaped entry with a closed membrane for cables of 5–14 mm diameter.

• 1 × DIGITUS DIN-rail splice distributor, angled (DN-96893)
• 1 × mounting bracket
• 1 × heat-shrink splice holder
• No couplers, pigtails or splice protectors

• Width on the rail is 45 mm, height 177 mm and depth 161 mm — check the cabinet depth and door clearance.
• With LC quad couplers you get the highest fiber count (24 fibers); with SC duplex couplers 12 fibers.
• Accepts crimp protectors (e.g. DIGITUS DN-CSP-015) and heat-shrink sleeves.
• The angled front reduces bending stress on patch cords in shallow cabinets.

• It does not work without couplers and pigtails — budget for them separately.
• Do not order it for SC simplex or LC duplex couplers — that is the DN-96894.
• It is not a 19" rack product and will not mount on rack rails.
• No IP rating is published, so use it inside a closed cabinet.