DIGITUS 19-inch 1U Sliding Fiber Splice Box, Equipped with 24x SC Duplex Couplers, OM4 Multimode, Light Grey

The DIGITUS DN-96322-4 is a 19-inch, 1U fiber optic splice box that arrives equipped with 24 SC duplex couplers, OM4 multimode (50/125 µm) colour-coded pigtails and a splice cassette, so the only job left on site is to fusion-splice your incoming installation cable to the pigtails. It is aimed at installers and IT teams terminating a 48-fibre OM4 cable in a network or server cabinet.

The tray slides forward out of the housing, which gives you room to splice, store fibre overlength in the cassette and re-patch later without dismantling the rack. The carrier housing is 1.0 mm sheet steel, powder-coated light grey (RAL 7035), with M20/M25 cable glands and strain relief for the incoming cable.

• 1x 19" 1U fiber optic splice box, sliding, light grey RAL 7035
• Equipped: 24x SC duplex couplers (ceramic sleeve) on the front panel
• Colour-coded OM4 pigtails, already routed and inserted into the splice cassette
• Splice cassette with cassette cover
• M20/M25 cable glands and strain relief for the incoming cable

• Capacity is 24 duplex ports = 48 fibres. Size it to the fibre count of the cable you are bringing in, plus any spares you want to land.
• Typical use: short-reach, high-bandwidth links inside a data centre or building backbone, where OM4 gives more headroom than OM3 at 10G and above.
• You need a fusion splicer, splice protection sleeves and a cleaver on site — or an installer who has them. The box itself is passive and needs no power.
• Front-side patching uses standard SC duplex patch cords in OM4; order them separately in the lengths you need.
• Sliding tray: pull the box forward for splicing and service, push it back to close — no need to remove it from the rack.

• It will not terminate a single-mode (OS2) cable — fibre type must match end to end.
• APC (green, angled) patch cords will not mate with these UPC couplers.
• No patch cords, installation cable, splice sleeves or tools are included.
• It does not fit 10-inch racks or wall boxes — it needs a 19-inch rack with at least 240 mm usable depth behind the mounting rails.
• It is not a pre-terminated plug-and-play panel: without splicing, the pigtails are not connected to anything.