DIGITUS DN-95407-FR 19" 1U Rack Power Strip, 7 x CEE 7/5 French Sockets, Surge Protection 5 kA, Switch, 16 A

The DIGITUS DN-95407-FR is a 19-inch, 1U rack power strip with seven French-standard CEE 7/5 sockets and a built-in surge protection module (nominal discharge current 5 kA), rated for a 16 A supply. It powers servers, switches and network equipment inside a rack and adds a first layer of protection against mains overvoltage.

It is built on an aluminium profile, has a master switch that cannot be switched off by accident, and its sockets are rotated 45° so angled plugs and adapters sit side by side. It suits racks where the equipment uses hybrid CEE 7/7 or French plugs.

• 1 x DIGITUS DN-95407-FR 19" socket strip with fixed 2 m supply cable (CEE 7/7 earthing-contact plug)
• 2 x 19" mounting brackets
• 1 x safety instructions
• No screws or cage nuts listed by DIGITUS — use the ones supplied with your rack

• Seven outlets in 1U with a surge module in front of them — a sensible upgrade over a plain strip for network gear on a mains line without other protection.
• The surge module is a basic first stage (In 5 kA). Behind a UPS with its own protection it adds little; on a raw mains line it helps.
• The guarded switch turns off all seven sockets at once for maintenance but will not be knocked off by accident.
• The 16 A limit applies to the whole strip — add up the loads you connect.

• Standard German Schuko plugs (CEE 7/4, no earth hole) — they will not go into French sockets.
• UK/Cyprus BS 1363 plugs — you need device cords with CEE 7/7 or French plugs.
• Plugging the strip into a Cyprus BS 1363 wall socket — it needs a Schuko/French outlet installed by an electrician, or a UPS with matching outputs.
• Replacement for a UPS — surge protection does not keep equipment running during a power cut.
• IEC C13/C19 server cords — this strip has no IEC outlets.