Digitus SC Fibre Optic Pigtail Set OM3 Multimode 50/125µm 12 Colours 2m 0.9mm LSOH

The Digitus DK-25221-02/3 is a set of twelve 2 m OM3 multimode 50/125 µm pigtails, each factory-terminated with an SC connector on one end and bare fibre on the other, for splicing onto incoming trunk or breakout cables in patch panels, splice boxes and distribution frames.

Each pigtail has a different colour so that fibre 1 to 12 of a trunk can be matched and labelled without mistakes — the usual way to terminate a 12-fibre cable with factory-polished connectors instead of field-fitting them.

• 12 × Digitus SC OM3 pigtails, 2 m, in 12 colours

• Typical job: strip the incoming 12-fibre OM3 cable in a patch panel, splice one pigtail to each fibre, and plug the SC connectors into the panel's adapters from the inside.
• The colour of each pigtail lets you follow the fibre order of the trunk, so port 1 is fibre 1 at both ends of the link.
• Factory-terminated connectors give consistent loss values, which is easier and more reliable than polishing connectors on site.
• The 2 m length leaves enough slack to coil the fibres in the splice tray and to re-splice once if a splice has to be redone.

• Plug-and-play patching — the second end is bare fibre and must be spliced.
• Single-mode (OS2) trunk cables — splice OM3 pigtails only onto 50/125 µm multimode fibre.
• Adapters or panels of another connector type — these fit SC adapters only.
• Use without splice protection sleeves and a splice tray — these are not included.