EFB-Elektronik 19-inch 1U Cable Routing Panel with 4 Brackets, Sheet Steel, Light Grey RAL 7035

The EFB-Elektronik 699995 is a 1U cable routing panel for 19-inch racks, with four steel brackets that hold patch cords horizontally across the front of the rack. It is made of sheet steel in light grey RAL 7035 and is intended for patch fields where cords run between a patch panel and a switch.

Each bracket is 60 mm long, and the panel is about 70 mm deep overall. That gives the cords a defined path without bending them tightly around device ears.

• 1 × EFB 19" 1U cable routing panel with 4 brackets, light grey RAL 7035
• EFB does not list mounting screws. Use 4 × M6 screws and cage nuts from your rack kit or a fixing set.

• A typical layout is patch panel – routing panel – switch. Each group of 6 to 12 cords drops into its nearest bracket.
• The four brackets divide the 19" width into sections, so each port group stays separate and easy to trace.
• The open bracket design means cords are laid in from the front. Nothing needs to be threaded through, so moves and changes are quick.
• The RAL 7035 finish matches light grey cabinets and EFB patch panels.

• 10-inch racks. The panel is 482.6 mm wide.
• Passing cables to the rear. There is no brush or opening, so the cables stay at the front.
• Cabinets with less than about 70 mm between the rails and the door.
• Bearing load. It is not a shelf.