HP Z2 Mini G9 Rail Rack Kit for Up to Six Z2 Mini G9 Workstations in 5U, Slide Rails, Tool-less Brackets

The HP Z2 Mini G9 Rail Rack Kit (6C1U0AA) mounts up to six HP Z2 Mini G9 workstations, standing vertically, on a slide-out tray that occupies 5U of a 19-inch rack. It is built for studios, broadcast facilities, engineering teams and remote-workstation setups that want a dense, serviceable block of Z2 Minis in the rack instead of on desks.

According to HP's rack-mounting white paper, the kit comes fully assembled with the hardware needed for a quick install: a rack-mount tray with six chassis brackets and six brackets for the external power supplies, plus slide rails with 26 inches of travel so the whole tray slides completely out for service. The adjustable outer rail members fit racks 24 to 36 inches deep, and the tool-less front and rear brackets suit 9.5 mm square, 7.1 mm round or #10-32 threaded holes.

• Rack-mount tray, supplied fully assembled
• 6 × mounting brackets for HP Z2 Mini G9 chassis
• 6 × mounting brackets for the external power supplies
• Set of slide rails with tool-less front and rear brackets and the hardware for installation

• Six Z2 Mini G9 units in 5U works out to less than one rack unit per workstation.
• Each workstation's external power supply has its own bracket on the tray, so power bricks are not left loose in the rack.
• The tray slides fully out on its rails for service; add HP's Cable Management Arm (35Z34AA) if you want to extend it without disconnecting cables.
• The rails adjust to rack depths from 24 to 36 inches and accept square, round or threaded mounting holes.

• Any Z2 Mini other than the G9 — the brackets are specific to the G9 chassis.
• Other mini PCs or thin clients.
• Racks shallower than 24 inches or deeper than 36 inches between front and rear rails.
• Two-post racks — the slide rails need front and rear mounting posts.