Intellinet 19-inch 1U Cable Entry Panel with Brush Insert, Powder-Coated Steel, Black RAL 9005

The Intellinet 712767 is a 1U cable entry panel with a brush insert for 19-inch racks and cabinets, made from 1.5 mm steel with an antistatic powder coating in black RAL 9005. It lets patch cords pass from the front of the rack to the back through a brush-sealed slot, so the front stays tidy and the open gap between devices is closed.

It is installed horizontally in one rack unit, normally directly above or below a switch or patch panel, and at 15 mm deep it adds almost nothing in front of the rails.

• 1 × Intellinet 19" 1U cable entry panel with brush insert, black RAL 9005
• Intellinet does not list mounting screws in the package. Plan on 4 × M6 screws and cage nuts from your rack kit or a separate fixing set.

• Put it between the patch panel and the switch. Short patch cords go in through the brush and come out behind, and the ports stay visible from the front.
• The brush closes around the cables, which helps airflow in cabinets with front-to-back cooling, since cold air is not lost through an open 1U gap.
• The antistatic powder coating makes it safe to use next to active equipment.
• Because it is only 15 mm deep, it does not conflict with a front door or with device ears next to it.

• 10-inch racks. The panel is 483 mm wide and needs 19" rails.
• Plugs that are larger than the brush slot, such as mains plugs or bulky adapters. Thread those cables before you mount the panel, or route them elsewhere.
• Storing slack. There are no rings or hooks, so use a ring or bracket panel for loops.
• Mounting without hardware. Screws and cage nuts are not listed in the box.