Intellinet 19-Inch Cable Entry Panel 2U with Brush Insert for Server and Network Racks, 1.5 mm Steel, Black

The Intellinet 712774 is a 2U, 19-inch cable entry panel with a brush insert: it fills a two-unit gap in a server or network rack and lets patch cords, power leads and fibre jumpers pass through the bristles instead of through an open slot. It suits anyone tidying a switch or patch-panel area who wants cables to reach the rear of the cabinet without leaving a hole in the front.

The panel is made of 1.5 mm steel with a black finish (Intellinet specifies RAL 9004) and is designed for horizontal installation. The bristles close around the cables, so the rack front stays covered, dust entry is reduced and the cable bundle is protected against sharp edges.

• 1 × Intellinet 19" 2U cable entry panel with brush insert
• Mounting screws and cage nuts are not listed by Intellinet — if your rack kit has run out, add a set of M6 screws and cage nuts to the order

• Pass cables from the front of the rack to the rear without leaving an open 2U gap
• Lets you run patch cords between a patch panel and a switch mounted at different depths
• The bristles reduce dust ingress and help keep front-to-back airflow working as designed
• A 2U opening gives enough room for thick bundles or cables with moulded connectors

• It does not fit 10-inch mini racks — the panel is 483 mm wide for 19-inch rails only
• It is not a sealed IP-rated grommet; it reduces dust but does not make a cabinet dust-tight or water-resistant
• It does not provide strain relief or tie points on its own — use a lacing bar or cable manager for that
• It is designed for horizontal mounting, not for vertical cable channels at the side of the rack